Schubert D, Rohrmoser A, Herzog C, Wolf M, Hagenah H, Merklein M, Drummer D (2023)
Publication Type: Journal article
Publication year: 2023
Book Volume: 43
Pages Range: 187-197
Journal Issue: 2
DOI: 10.1515/polyeng-2022-0231
Friction and wear in a tribological system are directly dependent on the surface structure and roughness of the friction partners involved. In this article, a clear interaction between surface topologies and their roughness depth was identified for the material pairing polyamide 66 - steel. The typical correlation between roughness and wear, initially decreasing and increasing after a wear minimizing roughness, was found for all surface topologies, albeit at different levels. The effect of the surface topology is negligible at low roughness (S z < 2.0 μm) with adhesive wear processes determining the wear behaviour. At higher roughness depths (S z > 2.0 μm), the ability of the surface topology to form a stable transfer film determines the tribological behaviour by limiting the effect of abrasive wear processes. A stable transfer film is formed with sufficient roughness and undercuts in the direction of motion, which can be characterised by the average roughness depth, R z , in the direction of motion. Based on these empirical results, an explanatory model for the observed behaviour is presented.
APA:
Schubert, D., Rohrmoser, A., Herzog, C., Wolf, M., Hagenah, H., Merklein, M., & Drummer, D. (2023). Influence of production process-induced surface topologies at varying roughness depths on the tribological properties of polyamide steel contact. Journal of Polymer Engineering, 43(2), 187-197. https://doi.org/10.1515/polyeng-2022-0231
MLA:
Schubert, Dominik, et al. "Influence of production process-induced surface topologies at varying roughness depths on the tribological properties of polyamide steel contact." Journal of Polymer Engineering 43.2 (2023): 187-197.
BibTeX: Download