Application of an edge detection algorithm for surface determination in industrial X‑ray computed tomography (2022) Busch M, Hausotte T Journal article, other Investigation of the influence of varying tumbling strategies on a tumbling self-piercing riveting process (2021) Wituschek S, Kappe F, Lechner M Journal article Analysis of stress pins for the local prestressing of cold forging tools (2021) Killmann M, Merklein M Journal article, Original article Joining of CFRT-steel hybrid parts via hole-forming and subsequent pin caulking (2021) Römisch D, Popp J, Drummer D, Merklein M Journal article Application of reinforcement learning for the optimization of clinch joint characteristics (2021) Zirngibl C, Dworschak F, Schleich B, Wartzack S Journal article, Original article Numerical and experimental investigations for distortion-reduced laser heat treatment of aluminum (2021) Rigas N, Merklein M Journal article Finite‑element‑analysis of the mechanical behavior of high‑frequency litz wire in flat coil winding (2020) Weigelt M, Thoma C, Zheng E, Franke J Journal article Data acquisition and control at the edge: a hardware/software-reconfigurable approach (2020) Streit FJ, Wituschek S, Pschyklenk M, Becher A, Lechner M, Wildermann S, Pitz I, et al. Journal article, Editorial Improvement of a rivet geometry for the self-piercing riveting of high-strength steel and multi-material joints (2020) Uhe B, Kuball CM, Merklein M, Meschut G Journal article Influence of tribological conditions on application relevant component properties of cold forged gears (2019) Rohrmoser A, Kiener C, Hagenah H, Merklein M Journal article