Polzer M, Bartz M, Rothammer B, Schulz E, Wartzack S (2023)
Publication Language: English
Publication Type: Journal article, Original article
Publication year: 2023
Pages Range: 1 - 10
Purpose
The curved and tribologically highly stressed surfaces of bearing components pose a major challenge for steel alloys or tribological resistant coatings like tetrahedral amorphous carbon (ta-C) coatings which in particular have an increased risk of delamination due to the significantly increased residual stresses. A possibility to prevent coating failure is the use of dopants while maintaining or even increasing tribological properties. This study aims to compare the tribological behavior of several doped diamond-like-carbon coatings with an undoped ta-C coating under varying slip conditions and Hertzian pressure up to 1800 MPa.
Design/methodology/approach
For this purpose, the tribological behavior was studied using of a ball-on-disc tribometer and a two-disc test rig under mixed/boundary conditions. The tests were conducted with coated specimens against uncoated 100Cr6 steel. Additionally, the influence of lubrication additives was studied due to the use of two fully formulated PAO-based oils, one without and one with molybdenum containing additives. The friction was measured in situ, and the wear was analyzed trough laser scanning microscopy and tactile measurement.
Findings
It was shown that the use of doped ta-C coatings exhibited a tendency for a more favorable tribological behavior compared to undoped ta-C coatings, with no general dependence on the lubricants used. The use of the most suitable coatings reduced the wear of the steel counter-body considerably.
Originality/value
To the best of the authors’ knowledge, this is the first approach of testing the tribological behavior of these doped ta-C coatings, developed for friction efficiency, in dependency on lubrication additives under the given load collective. The approach is relevant to determine whether the friction reduction and the wear inhibition of these coatings are suitable for higher contact pressures and load cycles.
APA:
Polzer, M., Bartz, M., Rothammer, B., Schulz, E., & Wartzack, S. (2023). Tribological behavior of different doped ta-C coatings for slip-rolling contacts with high hertzian contact pressure. Industrial Lubrication and Tribology, 1 - 10. https://dx.doi.org/10.1108/ILT-11-2022-0336
MLA:
Polzer, Markus, et al. "Tribological behavior of different doped ta-C coatings for slip-rolling contacts with high hertzian contact pressure." Industrial Lubrication and Tribology (2023): 1 - 10.
BibTeX: Download