Design, Fabrication, and application of precise delay lines at 2.45 GHz

Beitrag bei einer Tagung


Details zur Publikation

Autor(en): Ruppel CCW, Reindl L, Berek S, Knauer U, Heide P, Vossiek M
Titel Sammelwerk: Proceedings of the IEEE Ultrasonics Symposium
Verlag: Institute of Electrical and Electronics Engineers
Jahr der Veröffentlichung: 1996
Band: 1
Tagungsband: IEEE International Ultrasonics Symposium
Seitenbereich: 261-265
ISSN: 1051-0117
Sprache: Englisch


Abstract


For years linear optimization algorithms have been used successfully in bandpass filter design. This method has been adopted for the design of dispersive interdigital transducers (IDTs) for pulse compression filters with low time-bandwidth products, and for the design of delay lines with linear phase. Now this method has been extended to the design of dispersive IDTs operating at higher harmonics. As examples, delay lines at 2.45 GHz operating at the fundamental and third harmonic with relative bandwidths up to 30% will be presented. The delay lines operating at the fundamental harmonics were fabricated on the rotated cut of LiNbO3 and had normal fingers only. The relative height of the metallization was chosen for minimum reflections. Minimum linewidth of 0.3 μm were necessary. The delay lines operating at the third harmonic had split fingers for canceling reflections. Therefore minimum linewidths of approximately 0.45 μm had to be realized. Measured and calculated frequency responses of these delay lines will be compared with each other. Taking advantage of the reported delay lines, a novel FMCW radar system incorporating a 2.45 GHz SAW reference path is established. The proposed SAW based system achieves a higher dynamic range than the conventional FMCW radar sensors.



FAU-Autoren / FAU-Herausgeber

Vossiek, Martin Prof. Dr.-Ing.
Lehrstuhl für Hochfrequenztechnik


Zitierweisen

APA:
Ruppel, C.C.W., Reindl, L., Berek, S., Knauer, U., Heide, P., & Vossiek, M. (1996). Design, Fabrication, and application of precise delay lines at 2.45 GHz. In IEEE International Ultrasonics Symposium (pp. 261-265). San Antonio, USA: Institute of Electrical and Electronics Engineers.

MLA:
Ruppel, C. C. W., et al. "Design, Fabrication, and application of precise delay lines at 2.45 GHz." Proceedings of the Proceedings of the 1996 IEEE Ultrasonics Symposium. Part 2 (of 2), San Antonio, USA Institute of Electrical and Electronics Engineers, 1996. 261-265.

BibTeX: 

Zuletzt aktualisiert 2018-08-08 um 04:38