Andreas Meyer



close-button

Types of publications

Journal article
Book chapter / Article in edited volumes
Authored book
Translation
Thesis
Edited Volume
Conference contribution
Other publication type
Unpublished / Preprint

Publication year

From
To

Abstract

Journal

Verbesserung der Kriechbeständigkeit der pulverspritzgegossenen Nickelbasis-Legierung CM247LC durch Legierungsentwicklung und Wärmebehandlung (2021) Meyer A Thesis Secondary Recrystallization of Nickel-Base Superalloy CM 247 LC After Processing by Metal Injection Molding (2020) Sheng N, Meyer A, Horke K, Körner C, Singer R Journal article Influence of carbon content on the grain size and creep resistance of a metal injection moulded nickel-base superalloy (2019) Horke K, Keilholz P, Meyer A, Singer RF Conference contribution Metal injection molding (MIM) of nickel-base superalloys (2019) Horke K, Meyer A, Singer RF Book chapter / Article in edited volumes 3D grain growth simulation and experimental verification in laser beam melting of IN718 (2018) Köpf J, Rasch M, Meyer A, Markl M, Schmidt M, Körner C Conference contribution, Conference Contribution Oxidation Behavior of Superalloy IN 713 Fabricated by Metal Injection Molding (2018) Sheng N, Horke K, Meyer A, Rettig R, Singer R Journal article, Original article Metal injection molding of nickel-base superalloy CM247LC: Influence of heat treatment on the microstructure and mechanical properties (2017) Meyer A, Horke K, Daenicke E, Müller S, Langer I, Singer R Conference contribution, Conference Contribution Surface recrystallization and its effect on oxidation of superalloy C263 (2017) Sheng N, Horke K, Meyer A, Gotterbarm M, Rettig R, Singer R Journal article, Original article Metal Injection Moulding of Iron-Base Oxide Dispersion Strengthened Alloys (2016) Meyer A, Recknagel C, Klöden B, Weissgärber T, Müller S, Langer I, Horke K, et al. Conference contribution Influence of Heat Treatment on Tensile, Fatigue and Creep Properties of Nickel-Base Superalloy IN 713LC Fabricated by Metal Injection Moulding (2016) Horke K, Scherr R, Meyer A, Daenicke E, Singer R Conference contribution